Steps To Create BooTable Pendrive

Steps To Create BooTable Pendrive

1. Insert your USB in your CPU (atleast of 4GB). And make sure that you retrieve all your files and folders from it since we are about to format it.

2. Now open “Command Prompt” on your system. Follow the path to open command promptStart > All programs >Accessories > right click on Command Prompt and select run as administrator.

3. Now as soon as Command Prompt window prompt type following command:


• DISKPART follow by Enter and grant permission if your system prompt for permission.
• LIST DISK follows by Enter.

This command will display list of disk available on your system. As you can see that I got 2 disks on my system from which my drive is disk no.1

4. Sorry for a big list of Command, but if you want to make your USB as bootable then type the following command simultaneously follow by Enter. Don’t bother about the command just type it:

• SELECT DISK 1 (Replace DISK 1 with your disk number) + ENTER
• CLEAN + ENTER
• CREATE PARTITION PRIMARY + ENTER
• SELECT PARTITION 1 + ENTER
• ACTIVE + ENTER
• FORMAT FS=NTFS + ENTER
(Formatting May Take Few Seconds)
• ASSIGN + ENTER
• EXIT + ENTER
See The Screen Shot below

5. Wait yet we are not finish, don’t close your command prompt. Now just insert windows DVD in DVD W/R and check that drive initial(letter) of DVD W/R and USB Drive. In my case its ‘G’ for DVD W/R and ‘J’ for USB Drive.
6. Now back to command prompt and just few more command and you are done.

Now type the following command:
G: CD BOOT + Enter (‘G’ is DVD W/R drive letter)
CD BOOT + Enter
BOOTSECT.EXE/NT60 J: + Enter (‘J’ is USB Drive letter)

7. Congrats! You are done